![]() Video Tutorialīottle Scuba Diver Science Experiment Step by Step Instructional Video How Does the Science Experiment Work Write down your hypothesis (prediction) and try it out and observe what happens.ĭo you know why then you squeeze the bottle the diver sinks to the bottom and when you stop squeezing the diver floats back to the top.įind out the answer in the how does this experiment work section below. Step 6 – What do you think will happen when you squeeze the bottle? What about when you stop squeezing the bottle. Carefully place the diver into the bottle and screw on the lid. Make sure to fill it to the top, otherwise, the experiment won’t work. ![]() Step 5 – Fill the two-liter bottle with water. ![]() If it doesn’t float, your straw may have a hole in it. Step 4 – Fill a glass with water and put the diver in. Then place a small piece of play-dough or putty on the diver’s feet. The diver should look like he’s wearing a scuba tank. Step 3 – Slowly slide the straw onto the diver as shown above. Each end should be secured by the ends of the paper clip. Step 2 – Cut the straw and position it on the paper-clip as shown above. Helpful Tip: Download the Template for the Bottle Diver Here ![]() The diver should be approximated an inch and a half tall. I lightly sketched my diver on my foil before I cut him out. Step 1 – Cut out your diver using the same shape and size indicated above. JUMP TO SECTION: Instructions | Video Tutorial | How it Works Supplies Neededīottle Diver Science Experiment Instructions Kids will enjoyed taking turns making the scuba diver move up and down in the bottle. This experiment takes a few minutes to set up, but once done you can do the experiment over and over. ![]()
0 Comments
Leave a Reply. |